6-16
Design Guide
Integrated Services Platform BIOS Setup
The serial ports on the ISP must be configured with the proper Interrupt Request (IRQ) settings.
Note:
To change the IRQ settings, the ISP must be rebooted
Follow these steps to configure the IRQ settings on the ISP:
Step 1. Reboot the ISP that is connected to the Pelco keyboard and access the BIOS setup
screen.
Step 2. Select the
Integrated Peripherals
settings and make these settings:
Serial Port 3—use IRQ 10
Serial Port 4—use IRQ 11
Step 3. Choose
Save then Exit
to apply these changes.
Pelco CM9760-KBD Keyboard Setup
To program the keys on a Pelco CM9760 keyboard, make sure that the keyboard is connected
directly to the matrix switch (not to the ISP).
Make sure the keyboard is in Setup Mode by following these steps:
Step 1. Flip Dip Switch 2, which is located underneath the keyboard.
Step 2. Log in to the keyboard (the default password is 1234).
Step 3. Press the leftmost key (not the Esc key) in the row of blue keys.
Step 4. Continue to press this key until the cursor is next to FNC70.
Figure 70 shows the key mappings for the integration with the Pelco keyboard
Figure 70.
Pelco CM9760 Keyboard Integration
All contents are Copyright © 1992–2007 Cisco Systems, Inc. All rights reserved. This document is Cisco Public Information.
Page-6-16