B-49
Catalyst 3750 Switch Command Reference
OL-8552-07
Appendix B Catalyst 3750 Switch Debug Commands
debug platform ip dhcp
debug platform ip dhcp
Use the
debug platform ip dhcp
privileged EXEC command to debug DHCP events. Use the
no
form
of this command to disable debugging.
debug platform ip dhcp
[
all
|
error
|
event
|
packet
|
rpc
]
no debug platform ip dhcp
[
all
|
error
|
event
|
packet
|
rpc
]
Syntax Description
Defaults
Debugging is disabled.
Command Modes
Privileged EXEC
Command History
Usage Guidelines
The
undebug platform ip dhcp
command is the same as the
no debug platform ip dhcp
command.
When you enable debugging, it is enabled only on the stack master. To enable debugging on a stack
member, you can start a session from the stack master by using the
session
switch-number
privileged
EXEC command. Then enter the
debug
command at the command-line prompt of the stack member. You
also can use the
remote command
stack-member-number
LINE
privileged EXEC command on the stack
master switch to enable debugging on a member switch without first starting a session.
Related Commands
all
(Optional) Display all DHCP debug messages.
error
(Optional) Display DHCP error debug messages.
event
(Optional) Display DHCP event debug messages.
packet
(Optional) Display DHCP packet-related debug messages.
rpc
(Optional) Display DHCP remote procedure call (RPC) request debug
messages.
Release
Modification
12.1(19)EA1
This command was introduced.
Command
Description
Displays the DHCP snooping configuration.
Displays the DHCP snooping binding information.
show debugging
Displays information about the types of debugging that are enabled.