Cisco 3640 Series, User Manual, Page: 6 / 26

Configuration Tasks
6 Cisco IOS Release 12.0(3)T
13 Router(config-if)#isdn spid1 spid-number
[ ldn]
Specify a SPID and local directory
number for the B1 channel. Currently,
only the DMS-100 and NI-1 switch
types require SPIDs. Although the
5ESS switch type might support a
SPID, we recommend that you set up
that ISDN service without SPIDs.
14 Router(config-if)#isdn spid2 spid-number
[ ldn]
Specify a SPID and local directory
number for the B2 channel.
15 Router(config-if)#isdn caller number (Optional) Configure caller ID
screening.
16 Router(config-if)#isdn answer1
[ called-party-number]
[: subaddress]
(Optional) Configure called-party
number verification for a called-party
number or subaddress number in the
incoming setup message.
17 Router(config-if)#isdn calling-number
calling-number
(Optional) Specify the calling-party
number.
18 Router(config-if)#isdn not-end-to-end
[
56
|
64
]
(Optional) Configure the speed for
incoming calls not recognized as ISDN
end-to-end.
19 Router(config-if)#isdn incoming-voice
modem
Route incoming voice calls to the
modem and treat them as analog data.
This step is required for the Modem
over ISDN BRI feature.
20 Router(config-if)#isdn modem-busy-cause
{ number | busy | not available}
(Optional) Specify the message that is
returned when no modem is available
for a call. This command is optional for
the Modem over ISDN BRI feature.
number is a 1- to 3-digit number. Valid
values are from 1 to 127, denoting a
Q.931 error cause code.
busy specifies that the message will be
“USER BUSY” when modems are
unavailable.
not available specifies that the message
will be “CHANNEL NOT
AVAILABLE” when modems are
unavailable.
21 Router(config-if)#isdn
fast-rollover-delay seconds
(Optional) Configure a fast rollover
delay.
22 Router(config-if)#isdn sending-complete (Optional) Configure the BRI interface
to include the Sending Complete
information element in the outgoing
call Setup message. Used in some
geographic locations, such as Hong
Kong and Taiwan, where the sending
complete information element is
required in the outgoing call setup
message.
Step Command Purpose