![Cisco 350XG series Administration Manual Download Page 161](http://html.mh-extra.com/html/cisco/350xg-series/350xg-series_administration-manual_67491161.webp)
Administration: Discovery
Configuring CDP
Cisco 350XG & 550XG Series 10G Stackable Managed Switches
152
9
-
Use Default
—Use the IP address of the outgoing interface.
-
User Defined
—Use the IP address of the interface (in the
Interface
field)
in the address TLV.
•
Interface
—IF
User Defined
was selected for
Source Interface
, select the
interface.
•
Syslog Voice VLAN Mismatch
—Check to send a SYSLOG message when
a voice VLAN mismatch is detected. This means that the voice VLAN
information in the incoming frame does not match what the local device is
advertising.
•
Syslog Native VLAN Mismatch
—Check to send a SYSLOG message when
a native VLAN mismatch is detected. This means that the native VLAN
information in the incoming frame does not match what the local device is
advertising.
•
Syslog Duplex Mismatch
—Check to send a SYSLOG message when
duplex information is mismatched. This means that the duplex information in
the incoming frame does not match what the local device is advertising.
STEP 3
Click
Apply
. The LLDP properties are defined.
CDP Interface Settings
The Interface Settings page enables you to enable/disable CDP per port.
Notifications can also be triggered when there are conflicts with CDP neighbors.
The conflict can be Voice VLAN data, Native VLAN, or Duplex.
By setting these properties it is possible to select the types of information to be
provided to devices that support the LLDP protocol.
The LLDP-MED TLVs to be advertised can be selected in the
page.
To define the CDP interface settings:
STEP 1
Click
Administration
>
Discovery - CDP
>
Interface Settings
.
This page displays the following CDP information for each interface including the
OOB port.
•
CDP Status
—CDP publishing option for the port.