Administration: Discovery
Configuring LLDP
Cisco 350XG & 550XG Series 10G Stackable Managed Switches
136
9
LLDP MED Port Settings
The LLDP MED Port Settings page enables the selection of the LLDP-MED TLVs
and/or the network policies to be included in the outgoing LLDP advertisement for
the desired interfaces. Network Policies are configured using the LLDP MED
Network Policy page.
NOTE
If LLDP-MED Network Policy for Voice Application (
Page) is Auto and Auto Voice VLAN is in operation, then the device automatically
generates an LLDP-MED Network Policy for Voice Application for all the ports that
are LLDP-MED enabled and are members of the voice VLAN.
To configure LLDP MED on each port:
STEP 1
Click
Administration
>
Discovery - LLDP
>
LLDP MED Port Settings
.
This page displays the following LLDP MED settings for all ports (only fields not
described in the
Edit
page are listed):
•
Location
—Whether Location TLV is transmitted.
•
PoE
—Whether POE-PSE TLV is transmitted.
•
Inventory
—Whether Inventory TLV is transmitted.
STEP 2
The message at the top of the page indicates whether the generation of the LLDP
MED Network Policy for the voice application is automatic or not (see
). Click on the link to change the mode.
STEP 3
To associate additional LLDP MED TLV and/or one or more user-defined LLDP
MED Network Policies to a port, select it, and click
Edit.
STEP 4
Enter the parameters:
•
Interface
—Select the interface to configure.
•
LLDP MED Status
—Enable/disable LLDP MED on this port.
•
SNMP Notification
—Select whether SNMP notification is sent on a per-port
basis when an end station that supports MED is discovered; for example a
SNMP managing system, when there is a topology change.
•
Selected Optional TLVs
—Select the TLVs that can be published by the
device by moving them from the
Available Optional TLVs
list to the Selected
Optional TLVs list.
