Cisco 3310 Mobility Services Engine, Getting Started Manual

Page: 26 / 60

3-2
Cisco 3310 Mobility Services Engine Getting Started Guide
OL-17304-02
Chapter 3 Hardware Installation
Installing and Removing the Rack Handles
Installing and Removing the Rack Handles
The mobility services engine is shipped with rack handles pre-installed, so that the product can be easily
affixed to an equipment rack. This section includes procedures for removing and reinstalling the rack
handles.
This section contains the following topics:
• Removing the Rack Handles
•
Installing the Rack Handles
Removing the Rack Handles
To remove rack handles from a mobility services engine:
Step 1 Review the information in the “Safety Warnings” section on page 2-1 and the “Safety Guidelines”
section on page 2-3 .
Step 2
Power down the mobility services engine and unplug all peripheral devices and the AC power cable.
Step 3 Remove the two screws that hold the rack handle and the bezel in place, and remove the rack handle from
the mobility services engine as shown in
Figure 3-1 .
Step 4
Reattach the bezel with the screws.
Figure 3-1 Removing the Rack Handle
Step 5
Repeat Step 3 and Step 4 on the opposite side of the system.
Step 6 Plug all peripheral devices and the AC power cable into the mobility services engine.
Installing the Rack Handles
To reinstall the rack handles on a mobility services engine:
Step 1
Review the information in the “Safety Warnings” section on page 2-1 and the “Safety Guidelines”
section on page 2-3 .
Step 2 Power down the device and all attached devices. Disconnect the power cord and all external cables.
00
Series
ce S
er
ver
2
3
111
9