3-14
Cisco Wireless LAN Controller Configuration Guide
OL-17037-01
Chapter 3 Configuring Ports and Interfaces
Configuring the Management, AP-Manager, Virtual, and Service-Port Interfaces
Using the CLI to Configure the AP-Manager Interface
Follow these steps to display and configure the AP-manager interface parameters using the CLI.
Step 1
Enter
show interface summary
to view the current interfaces.
Note
If the system is operating in Layer 2 mode, the AP-manager interface is not listed.
Step 2
Enter
show interface detailed ap-manager
to view the current AP-manager interface settings.
Step 3
Enter
config wlan disable
wlan-number
to disable each WLAN that uses the AP-manager interface for
distribution system communication.
Step 4
Enter these commands to define the AP-manager interface:
•
config interface address ap-manager
ip-addr ip-netmask
gateway
•
config interface vlan ap-manager
{
vlan-id
|
0
}
Note
Enter
0
for an untagged VLAN or a non-zero value for a tagged VLAN. Cisco recommends
using tagged VLANs for the AP-manager interface.
•
config interface port ap-manager
physical-ds-port-number
•
config interface dhcp ap-manager
ip-address-of-primary-dhcp-server
[
ip-address-of-secondary-dhcp-server
]
•
config interface acl ap-manager
access-control-list-name
Note
See
for more information on ACLs.
Step 5
Enter
save
config
to save your changes.
Step 6
Enter
show interface detailed ap-manager
to verify that your changes have been saved.
Using the CLI to Configure the Virtual Interface
Follow these steps to display and configure the virtual interface parameters using the CLI.
Step 1
Enter
show interface detailed virtual
to view the current virtual interface settings.
Step 2
Enter
config wlan disable
wlan-number
to disable each WLAN that uses the virtual interface for
distribution system communication.