4-11
Cisco 1900 Series Hardware Installation
OL-19084-02
Chapter 4 Installing and Connecting the Router
Connecting WAN and LAN Cables
Step 4
Connect the other end of the ground wire to a known good electrical ground point. Consult with a
licensed electrician if you have any questions about the suitability of the ground connection.
Connecting WAN and LAN Cables
•
Safety Messages, page 4-11
•
Ports and Cabling, page 4-13
•
Connection Procedures and Precautions, page 4-14
Note
You can order additional network connection cables and transceivers from Cisco. For ordering
information, contact Cisco customer service. For cable pinouts, refer to
Cisco Modular Access Router
Cable Specifications
.
Safety Messages
Warning
Do not work on the system, or connect or disconnect cables during periods of lightning activity.
Statement 1001
Warning
Voice over IP (VoIP) service and the emergency calling service do not function if power fails or is
disrupted. After power is restored, you might have to reset or reconfigure equipment to regain access
to VoIP and the emergency calling service. In the USA, this emergency number is 911. You need to be
aware of the emergency number in your country.
Statement 361
Warning
Do not use this product near water; for example, near a bath tub, wash bowl, kitchen sink or laundry
tub, in a wet basement, or near a swimming pool.
Statement 1035
Warning
Never install telephone jacks in wet locations unless the jack is specifically designed for
wet locations.
Statement 1036
Warning
Avoid using a telephone (other than a cordless type) during an electrical storm. There may be a remote
risk of electric shock from lightning.
Statement 1038
Warning
To report a gas leak, do not use a telephone in the vicinity of the leak.
Statement 1039
