Using Your Hub Software
3-9
Configuring IP and SNMP Parameters
Configuring IP and SNMP Parameters
The illustration below shows the network that is being configured in this section:
Figure 3-2
Example Network
Note
The network addresses used in the steps below are examples only; they will not work
for your network. You should substitute them with the IP addresses that apply to your
network devices.
Step 1
Use the
ip address
command to configure the hub’s IP address, subnet mask,
and gateway address:
Hub#
ip address 172.16.10.2 255.255.255.0 172.16.10.1
Step 2
Use the
snmp community
command to configure the SNMP communities and
their options:
Hub#
snmp community 1 private rw
Server
PC
PC
PC
SNMP network
management station
Micro Hub 1503
Router A
S6280
E0
E1