VCC-GC20U11CL
Rev.900-722-32-00
©2011 CIS Corporation. All rights reserved.
23
14.
Cases for Indemnity (Limited Warranty)
We shall be exempted from taking responsibility and held harmless for damage or losses incurred by
the user in the following cases.
In case damage or losses are caused by fire, earthquake, or other acts of God, acts by third
party, deliberate or accidental misuse by the user, or use under extreme operating conditions.
In case indirect, additional, consequential damages (loss of business interests, suspension of
business activities) are incurred as result of malfunction or non-function of the equipment, we
shall be exempted from responsibility for such damages.
In case damage or losses are caused by failure to observe the information contained in the
instructions in this product specification & operation manual.
In case damage or losses are caused by use contrary to the instructions in this product
specification & operation manual.
In case damage or losses are caused by malfunction or other problems resulting from use of
equipment or software that is not specified.
In case damage or losses are caused by repair or modification conducted by the customer or
any unauthorized third party (such as an unauthorized service representative).
Expenses we bear on this product shall be limited to the individual price of the product.
15.
Sensor Pixel Defect
Sensor pixel defects might be noted with time of usage of the products.
Cause of the Sensor pixel defects is the characteristic phenomenon of CMOS itself and CIS is exempted
from taking any responsibilities for them.
16.
Product Support
When defects or malfunction of our products occur, and if you would like us to investigate on the cause
and repair, please contact your distributors you purchased from to consult and coordinate.
Camera control sample software (RS232C) is downloadable from our web but
we shall be exempted
from taking responsibility and held harmless for damage or malfunction of your hardware and
software caused by using this control software. The purpose of the control software prepared
is for you to check operation and evaluate our products. Please be noted that CIS does not
customize the program nor provide source code.
Compliments
of
Phase1tech.com
