![background image](http://html1.mh-extra.com/html/cis/vcc-5cl1m/vcc-5cl1m_product-specification-and-operational-manual_2608691031.webp)
VCC-5CL1M
Rev.
905-0003-02
©2015 CIS Corporation. All rights reserved.
30
【
Example for SAVE Command
】
[Send]
SAVE[¥r]or[¥n]
[Returned
value]
[¥r]
[¥n]
[Linefeed]
[Returned
value]
>[sp] [Prompt
+
Space]
(5)
[¥r]or[¥n]
Make sure to input to indicate the end of the command.
(6)
Initial settings
Input “INIT” to return to the factory settings. (Data are not saved at this point.)
(7)
Data Save
Input “SAVE” to save the camera settings.
[Returned
value]
[¥r]
[¥n]
[Linefeed]
[Returned
value]
>[sp] [Prompt
+
Space]
14.
S
equence Control Function
□
select one for every trigger input from the preset parameter sets, and apply the parameters to the camera.
□
The number of parameter sets which can be preset is 8 at maximum. The following parameters can be set for each set.
Settable parameter
:
Shutter, Gain Setting, ROI start position (X, Y), Horizontal Size, Vertical Size
□
Operation sequence is specified as "Index". The parameter set number to be applied is specified against 8 Index(es)
at maximum.
□
For control modes, 2 types of Auto mode and CC mode are possible.
□
When using a sequence control function, set up the following operation mode beforehand:
・
Trigger Shutter Mode: Fixed Shutter Mode or Pulse width trigger shutter mode (Normal Shutter Mode is
prohibited)
・
Vertical Partial Mode: Disabled. To be operating at the Sequence Control setting.
・
Horizontal Partial Mode: Set the maximum pixel to be used at Sequence Control.
・
Binning/HDR Mode,/Defect Pixel Correction,/Binarization,/Shading Correction: OFF
□
Timing regulation:
・
Trigger input timing regulation of the Sequence Control is the same as the normal mode.
(Please refer to Section 7.9 and Section 7.10)
・
CC2
~
4 signals have to be stable at the rising edge of a trigger input. (setup time = 50[ns])