VCC-120CXP1M/VCC-120CXP1R Preliminary Rev.905-0120-Z1
©2017 CIS Corporation. All rights reserved.
18
4.16.
Noise Filter
□
This is a function to correct defective pixels in real time.
AnalogControl
ImpulseNoiseFilter
Off
ValiableByGainMode
FixedValueMode
ImpulseNoiseFilterThreshold 0~1023
ImpulseNoiseFilter
When set to OFF, correction function will be invalid.
When set to ValiableByGainMode, the value of ImpulseNoiseFilterThreshold changes corresponding to gain
settings (in the range of x1 to x8), and will be corrected by the internally set value in the camera.
When set to FixedValueMode, correction will be done with the value set by ImpulseNoiseFilterThreshold.
When set to OFF or ValiableByGainMode, the value of ImpulseNoiseFilterThreshold cannot be changed.
When set to FixedValueMode, the value of ImpulseNoiseFilterThreshold can be changed.
※
There might be some bad effects due to excessive correction. Please check images to use.
ImpulseNoiseFilterThreshold
This is the threshold of defective pixels and its surrounding pixels. When the value exceeded its threshold in
plus and minus, the surrounding pixels are to be used to correct.
※
When 1023 is set as the threshold, no defective pixel will be detected.
※
Please check the images to adjust the threshold.
4.17.
Link Speed and Link Count
Transfer Control
ConnectionConfig
CXP3_X4
CXP6_X2
CXP6_X4
CXP3_X4
：
Link speed
＝
3.125Gbps, Link count
＝
4
CXP6_X2
：
Link speed
＝
6.250Gbps, Link count
＝
2
CXP6_X4
：
Link speed
＝
6.250Gbps, Link count
＝
4
4.18.
How to Save and Initialize the Settings
□
If you wish to save the setting values, execute
“
UserSetSave
”
. Doing so, the setting values shall be saved in the
camera non-volatile memory and the saved settings data shall be reflected when the camera is turned on next
time
UserSets
UserSetSave
Execute
UserSetDefault
Execute
UserSetSave
：
This is to save the setting values of the camera
UserSetDefault
：
This is to restore the camera setting values to the ex-factory settings.
□
When executing "UserSetDefault", set ConnectionConfig to "CXP3_X4" to execute.
□
Camera settings shall be restored to the factory settings right after completion of UserSetDefault. However,
there would be some cases that command indications are not updated depending on its indication software used.
Please make sure to update the command.
