CIRRUS DESIGN CAPS, Component Manual

Page: 35 / 48

12128-001
95-01
Page 27 15 Sept 2002
(f) Route activation cable aft, through improved BH 222 cable pass-through and up through
LH cable pass-through hole in CAPS bucket.
(g) Loosely attach activation cable to forward and middle cable tie anchors with cable ties.
(h) Ensure activation cable is routed through shield slot, install cable grommet, and secure
with silicon sealant.
(i) Between middle and aft cable ties, solvent clean with isopropyl alcohol and apply two-
sided tape primer 3.0 inches (7.6 cm) either side of activation cable routing leaving the last
three inch section, just forward of aft cable tie anchor, uncovered.
(j) Loosely attach activation cable to aft cable tie anchor with a cable tie.
CAUTION: Verify activation cable routing is correct, is free and clear of other compo-
nents, and activation cable does not contact edges of improved BH 222
cable pass-through hole.Install CAPS routing placards along new cable
route.
(k) Cut aluminium tape into three sections and install aluminium tape over activation cable
leaving the last three inch section of activation cable, just forward of aft cable tie anchor,
uncovered.
(l) Install spiral wrap to forward portion of activation cable so that cable will not chafe on
speaker or antenna installations.
(m) Install spiral wrap to aft portion of activation cable behind BH 222 so that cable will not
chafe on static lines or BH 222 cable pass-through hole.
(n) Perform Operational Check - Caps Activation Handle & Cable Assembly. (Refer to 95-01)
(o) Install CAPS Rocket Assembly. (Refer to 95-01)
(p) Position cabin headliner to ceiling and install CAPS handle recess trim.
(q) Install LH B-pillar trim.
(r) Install tape securing headliner to door frame.
(s) Install LH and RH door seal to top edge of door frames.
(t) Install LH and RH cabin flood light assemblies.
(u) Install LH rear headliner.
(v) Remove catch cloth from below rocket and parachute assembly.
(w) Install access panels CB6 and CB7 from BH 222.
(x) Install BH 222 trim panel and carpet.
(3) Operational Check - Caps Activation Handle and Cable Assembly
(a) Acquire necessary tools, equipment, and supplies.
(b) Insert activation cable loop into test fixture tube and position cable over test fixture hook.
(c) Screw activation cable cone adapter to test fixture.
(d) Position test fixture to BH 222 and secure with knurled nuts.
(e) Route test fixture wiring forward to passenger seat.
(f) Connect test fixture wiring.
(g) Turn test fixture power unit to ON.
(h) Remove CAPS handle safety pin.
Description P/N or Spec. Supplier Purpose
CAPS Activation Cable
Test Fixture TBD Cirrus Design Testing.