Circutor URBAN WB Series, Installation Manual, Page: 19 / 24

URBAN WB
Installation guide 19
Verification
1 — P OW E R I N P U T
Before proceeding, make sure voltage is present in the terminal blocks.
For Three-Phase models pay special attention to Neutral Cable.
2 — M A I N T E N A N C E M O D E
Pull outward the Tamper Switch located in the lower half of the Charge Point.
3 — CA R E F U L W I T H T H E W I R E S
When closing the unit, keep in mind all cables should remain inside.
4 — C H E C K T H E P LU G S
Plugs should be in good conditions before starting the unit.
5 — O P E R AT I O N
Check no abnormal noise appears while the unit is charging.
6 — C H E C K T H E B E AC O N I N D I CATO R S
All beacon indicators should light properly. Here’s the reference:
P LU G S TAT E
Av a i l a b l e
C h a rg i n g
Fa u l t
B E AC O N C O LO R
G re e n
B l u e
R e d
G