Circutor Line-CVM-D32, Instruction Manual

Page: 60 / 106

60
line-CVM-D32
Instruction Manual
Use keys and to modify the digit's value.
Press key to skip through the digits.
Hold down key to validate the value.

Tariff 3 and 4 ratio per kWh in generation
Minimum value: 0.00000 EUR
Maximum value: 99.99999 EUR
Use key to skip to the next programming point.
6�6�- CONFIGURATION OF DIGITAL OUTPUTS 1 AND 2
Note: Digital output 1 configuration is identified by the literal OUT1 at the bottom right-hand side of
the display. Literal
OUT2
corresponds to digital output 2.
6�6�1�- VARIABLE
This screen enables configuration of the digital output variable
(VARIABLE)
.
SETUP
VARIABLE
1
V1
OUT1
Hold down key to enter programming mode.
Use keys and to modify the digit's value.
Press key to skip through the digits.
The codes for the variables are shown in
Table 10, Table 11, Table 12, Table 13
and
Table 14�
To validate the option, hold down key .
Use key to skip to the next programming point.
Table 10: Variable codes for Digital Output programming (Table 1)�
Parameter Phase Code Phase Code Phase Code Phase Code
Phase-Neutral voltage L1 1 L2 9 L3 17 III 31
Phase-Phase voltage L12
28
L23
29
L31
30
III
32
Current L1
2
L2
10
L3
18
III
33
Frequency - 27 - - - - - -
Total Active Power L1 3 L2 11 L3 19 III 34
Consumed Active Power L1 700 L2 707 L3 714 III 721
Generated Active Power L1
728
L2
735
L3
742
III
749