eHome Link
7
Instruction Manual
So, hello!
Read carefully all the instructions before starting in order to ensure
properly installation of the Charge Point.
I M P O R TA N T S A F E T Y I N S T R U C T I O N S
The Charge Point is designed for installation in indoor and outdoor areas. For each of the different
conditions of installation, the unit shall be installed safely and assuring the adequate protections.
• Charge Point must not be installed in areas
where potential risk of explosions are.
• Do not install the Charge Point where falling
objects may damage the equipment.
• The Charge Point can be installed in
locations with non-restricted access.
• The surface where the Charge Point is
placed must withstand the mechanical
forces.
• This unit shall not be used for any other
purpose than electric vehicle charging
modes as specified in IEC 61851.
• Do not modify this unit. If modified,
CIRCUTOR
will reject all responsibility and
the warranty will be void.
• The Charge point does not support the
ventilation optional function described in
IEC 61851-1:2017 (clause 6.3.2.2).
• Do not use any adapter, except those
approved by the EV manufacturer. Adapter
only allowed to
eHome Link
models with
socket-outlet.
• Do not perform any repair or manipulation
of the unit while it is energized.
• Only trained and qualified personnel should
be able to access to low-voltage electrical
parts inside the unit.
• Check the installation annually by qualified
technician.
• Remove from service any item which have
a fault that could be dangerous for users
(broken plugs, caps that don’t close...).
• Use only
CIRCUTOR
supplied spare parts.
• Do not use this product if the enclosure or
the EV connector is broken, cracked, open,
or shows any other indication of damage.
