Circutor DHC-96 CPM, Instruction Manual

Page: 27 / 56

27
Instruction Manual
DHC-96 CPM 1500
To validate the data, press the key.
Use the and keys to browse the configuration screens of the menu.
5�3�4�-READING FOR THE END OF THE ANALOG OUTPUT
In this screen, the reading value from which the analog output ends is configured.
FS
1000
V
Use the , key to modify the value of the flashing digit
When the desired value is shown on the screen, press the key to skip the digit.
Minimum configuration value: > 0.5 x A .
Note: The value of the A variable varies depending on the analog output parameter programmed, see
Table 8
.
Maximum configuration value:
1.2 x
A
, for the analog output of the voltage measurement,
1.2 x A , for the analog output of the current measurement
A
, for the analog output of the power measurement.
Note: FS
(End of the analog output) -
DS
(Start of the analog output) ≥ 500
To validate the data, press the key.
Use the and keys to browse the configuration screens of the menu.
5�3�5�- SAVE CONFIGURATION
To save the configuration of the device, press the key, until the main screen of the analog output
menu is opened,
Figure 17
.
Press the key again to show the validation screen.
no
SAuE
Use the key to browse the different options:
no
, exit the configuration without saving the changed values.
YES
, save the changed configuration values.
Press the key to validate the data and exit the configuration menu.