Circutor DHC-96 Aac, Instruction Manual

Page: 9 / 46

3.2.- INSTALLATION
Terminals, opening covers or removing elements can expose parts that are
hazardous to the touch while the device is powered. Do not use the device
until it is fully installed.
The device should be installed inside an electric panel or enclosure, and panel-mounted.
To install it, take the following steps:
1�- Make a cut in the panel, according to the dimensions in
Figure 1
�
91
44
Figure 1: Cut in the panel�
2�- Remove the device’s fixing clips (
Figure 2
).
Clip de fijación / Fixing clip
Figure 2: Installation�
3�- Insert the device into the cut in the panel.
4�- Fit the fixing clips until the device is fixed to the panel.
The device should be connected to a power circuit protected by a fuse with a maximum nominal
current of 0�25 A .
9
Instruction Manual
DHC-96 Aac