4�3�- DISPLAY
The device has a backlit LCD display showing all the parameters listed in
Table 3
.
The display is divided into four areas (
):
Figure 23: CVM-C10 Display areas
The area with
data per phase
displays the instantaneous, maximum and minimum values of
each phase being measured or calculated by the device.
The
total data
area displays the totals of the values being measured or calculated by the
device.
Analogue bar,
displays the % of the current power of the installation.
Cos
φ
- PF Bar
,
displays the value of the system's Cos
φ
or power factor in real time.
4�3�1� cos
φ
- PF (POWER FACTOR) BAR
Figure 24: Cos
φ
- PF Bar
This bar displays the value of the installation's cos
φ
or power factor in real time.
The parameter that will be displayed is selected on the programming menu. (
Note:
This bar will not be displayed in the IEC and IEEE measurement conventions.
35
Instruction Manual
CVM-C10
