Circutor CEM-C10, Instruction Manual

Page: 18 / 36

4�7�- CONFIGURATION
In the setup menu you can:

Program the weight and type of impulse output.

Program the communications.

Program the display screen.

Program the cost of the energy and the CO
2.
emissions

Delete the partial energy meters.
The standby mode is activated again when no key is pressed for 60 seconds.
Long press the
key in the standby mode screen to open these setup screens. Short press the key
to display the home screen,
Figure 10
:
Figure 10: Programming home screen
Long press the key to access the first programming step.
4�7�1� Impulse output weight
This is the home screen for entering the weight of the impulse output.
Long press the key to view the value to be programmed.
To write or modify the value, short press the key repeatedly,
increasing the value of the flashing digit.
When the desired value is shown on the screen, move onto the next digit with a long press on the
key, allowing the remaining values to be modified.
To validate the data, move to the last digit and long press the key; the validation screen will
appear (
Figure 11
) indicating that the programming value has been saved.
18
CEM-C10
Instruction Manual