Circutor CEM-C10, Instruction Manual

Page: 10 / 36

3�5�- CONNECTIONS
The
CEM-C10
has terminal covers to cover the top of the terminal box and the fixing screws (
Figure 3
).
Figure 3: Terminal covers of the CEM-C10�
The fixing screws are of the mixed type, allowing the use of PZ2 and flat head screwdrivers.
Table 3: CEM-C10 connections�
Connections
Measurement terminals ( 1, 3, 4, 6)
Maximum cable cross-section
25 mm
2
( 16 mm
2
with end sleeve) ≤ 1.7 Nm
Screwdrivers head flat head (1.2 x 6.0 mm) or PH2
Impulse output terminals ( 21, 22 )
Maximum cable cross-section
1.5 mm
2
( 1.5 mm
2
with end sleeve ) ≤ 0.6 Nm
Screwdrivers head
flat head (3 x 0.5 mm)
Once connected, the unit can be protected with two connection seals (
Figure 4
).
Figure 4: Seal of the CEM-C10�
10
CEM-C10
Instruction Manual