Circutor AFQm IP54, Instruction Manual

Page: 123 / 174

123
Instruction Manual
AFQm IP54
ENGLISH
6.- DISPLAY
6.1.- MAIN SCREEN
6.1.1. - DEVICE SINGLE OR MASTER
Figure 28
shows the main screen of a
“single”
or
“master”
device.
Active Power
Reactive Power
Current THD
Mains
Status messages
START / STOP / RESET key
% of filter power
Load
Active Power
Reactive Power
Current THD
Figure 28: Main screen.
It shows the Active Power and Reactive Power values, as well as the Current THD value in the Mains
and in the Load. The
% of filter power
used .
The key allows you to restart the device if an alarm has been generated and this has been
resolved.
The / key is the start and stop key of the active filter.
In the lower left part of the screen, a message with the current status of the device is shown (
Table 13
).
Table 13: Status messages
Status messages
Starting
Description The AFQm IP54 is starting up.
Init
Description
The device is starting the systems.
Waiting comms
Description Initiating internal communication systems
Waiting for conditions
Description Waiting for the conditions to be met in order to operate.
Calibration
Description
Calibrating the internal sensors.