70
AFQevo
Instruction Manual
7.9.- ETHERNET COMMUNICATIONS
The communication parameters are configured in this screen,
Figure 72:
Configuration screen: Communications.
By activating the DHCP option
, the device assigns the IP automatically.
If this option is not activated, the parameters must be configured manually:
●
IP
Address,
IP address.
●
Netmask,
subnet mask.
●
Gateway,
gateway.
Press the
key to access the next configuration step
Press the
key to access the main screen of the device without saving the configuration
values.
7.10.- RS-485 COMMUNICATIONS
The RS-485 communications configuration in
AFQm
models is set to a Baud rate of 9600 bps,
8 data bits, 1 stop bit and no parity. Only the device’s Modbus address can be configured,
Figure 73:
Configuration screen: RS-485 communications.
