CircuitWerkes Sicon-8, Operation & Technical Manual, Page: 15 / 32

Sicon-8 Technical Manual CircuitWerkes, Inc.
15
00 - AutoScan active channels for readings
01 thru 16 - Select a channel to read/control
65 - X10 On Commands (01 thru 16)
66 - X10 Off Commands (01 thru 16)
90 - Play 15-Second Test Tone
91 - Enter System Setup Menu (where all user programming is done – See pp21-26).
92 - Report alarms
93 - Report unread alarms
94 - Toggle remote/local mode (requires special password)
95 - Turn on audio monitor for 15 seconds
96 - Report firmware version
97 - New Login (requires entering a valid password
98 - TAD (telephone answering device) mode
99 - Immediate hangup command
Main menu commands are global. In other words, they are available from the “main menu” or from
any of the sub-menus. Submenu commands are available only while in that sub-menu. Each of the
above sub-menus is explained below.
00 – AutoScan
. This command reports the status & meter readings for each active channel. An
active channel is one that has been selected during setup to be part of the AutoScan channel list.
See the channel setup sub-menu for how to enable AutoScan for each channel.
01 –16 – Channel menu:
When you enter a channel, the Sicon-8 immediately reports all parameters for that channel. You
may enter a DTMF command at any time during the channel report and the Sicon-8 will stop its
report and perform the requested function. Available commands are:
70: AutoScan channel enable (Individual channel alarms require AutoScan enabled)
71: Calibrate and setup meter
72: Set status mode (normal/inverted)
73: Setup alarm
74: Enable/Disable alarm dialing
75: Setup critical alarm phone numbers
76: Jump to (or return to) the alarm stack
77: Reads the meter for that channel
78 - Set relay mode; momentary or latching (channel 7,8,15 & 16 only)
79 - Enable/disable tied relays
80: Record the meter label for the current channel
81: Record the status label for the current channel
88: Reads the status input for that channel
*
- Operates the channel’s RAISE relay for the duration of the DTMF tone.
# - Operates the channel’s LOWER relay for the duration of the DTMF tone.
NOTE:
For your reference when configuring words, there is a list of all words in Appendix A at the back of
the manual. Also, there is a list of the default words assigned to the “Units” words on the last page
of this manual, before appendix A.