Now is the time to put buttons and encoder caps to make your experience
smoother.
We'll start with the encoder caps. Those are the two biggest caps from the bag.
Put it right here:
Make sure to push the cap on the encoder until it clicks.
After putting them on the encoders, try to use them a bit to see if everything is put
on correctly.
The next thing we'll need is the pushbutton caps.
As for the encoder caps, push them on the button until they click.
Make sure everything works smoothly before going to the next step.
This is what Synthia should look like right now:
The next thing to do is put caps on sliders.
After putting them on, slide them a bit to make sure everything works as it should!
Great job!
We came to the end of the assembly.
The only thing left to do is to put adhesive rubber feet at the bottom of the device
to secure it.
These are the parts you'll need:
