– 10 –
For maximum accuracy it is recommended that the conductor passes
through the centre of the clamp head opening (use the centering marks
on the jaws as a guide).
➔
Apply power to the AC line being measured.
➔
Read the displayed current indicated with proper decimal point and
symbols.
➔
Open clamp jaws and release.
5. RESISTANCE MEASUREMENT
WARNING:
REMOVE ALL POWER FROM CIRCUIT BEING TESTED WHEN CHECKING
RESISTANCE. DISCHARGE ANY CHARGED CAPACITORS. NEVER CONNECT THE PROBES
TO ANY VOLTAGE WHILE THE FUNCTION IS SET TO
/
.
➔
Plug the red test lead into / jack and the black test lead into
COM
jack.
➔
Press the Power button.
➔
ʻ400.0ʼ, and and will appear on the display with the digit ʻ4ʼ flashing.
➔
Press / pushbutton once, M will now appear on the display.
➔
Apply the test leads to the circuit to be measured.
➔
Read the displayed resistance with proper decimal point and symbols
( or K or M ).
6. CONTINUITY TEST
WARNING:
REMOVE ALL POWER FROM CIRCUIT BEING TESTED WHEN CHECKING
CONTINUITY. DISCHARGE ANY CHARGED CAPACITORS. NEVER CONNECT THE PROBES TO
ANY VOLTAGE WHILE THE FUNCTION IS SET TO
/
.
➔
Plug the red test lead into / jack and the black test lead into
COM
jack.
➔
Press the Power button.
➔
ʻ400.0ʼ, and and will appear on the display with the digit ʻ4ʼ flashing.
➔
Touch the test probe tips to the circuit or wire you wish to check.
➔
If the resistance is less than 36 , the audible signal will sound. The display
will also show the actual resistance in ohms with proper decimal point.
NOTE: The display will read up to a maximum of 400 ohms in Continuity mode.
