CIRCUIT DESIGN SLR-434M, Operation Manual

Page: 11 / 15

OPERATION GUIDE
OG_SLR-434M_v10e Circuit Design, Inc.
11
Channel Frequency Channel Frequency Channel Frequency
NO. HEX (MHz) NO. HEX (MHz) NO. HEX (MHz)
102 66 434.3500 114 72 434.5000 126 7E 434.6500
103 67 434.3625 115 73 434.5125 127 7F 434.6625
104 68 434.3750 116 74 434.5250 128 80 434.6750
105 69 434.3875 117 75 434.5375 129 81 434.6875
106 6A 434.4000 118 76 434.5500 130 82 434.7000
107 6B 434.4125 119 77 434.5625 131 83 434.7125
108 6C 434.4250 120 78 434.5750 132 84 434.7250
109 6D 434.4375 121 79 434.5875 133 85 434.7375
110 6E 434.4500 122 7A 434.6000 134 86 434.7500
111 6F 434.4625 123 7B 434.6125 135 87 434.7625
112 70 434.4750 124 7C 434.6250 136 88 434.7750
113 71 434.4875 125 7D 434.6375
※ *The channel is set to No. 74 (434.000 MHz) for shipment.
※
*If you intend to use several SLR-434M units in the same area, use a channel plan that takes into
account radio interference due to third-order intermodulation.
Circuit Design provides a computational tool on our website for creating channel plans that avoid
interference due to third-order intermodulation. Calculation tool:
http://www.cdt21.com/resources/siryo6.asp
8. UART port communication settings
The serial communication conditions for the UART port of this product are as follows.
Communicatio
n speed
19,200 bps
Fixed value
Cannot be
changed.
Data 8-bit
Parity None
Stop 1-bit
Flow control
Hardware: RTS/CTS pin
(Software flow: Xon/Xoff is not used)
(The RTS output terminal is normally Lo. When the CTS input terminal is “Hi”, UART data is not
output)
Note: The UART serial communication terminals (TXD/RXD/RTS/CTS) cannot be connected
directly to a PC or other Com port because the signal level and logic is different.