This warranty is solely for the benefit of the original consumer
purchaser and is in effect from date of purchase.
Circle Specialty Inc. warranties that the Pango Activity Chair will
be free from defect for a period of two (2) years.
The warranty does not extend to non-durable components or any
components that are subject to standard wear and tear.
This warranty does not cover device failure due to owner misuse
or negligence. It only applies when product is used according to the
specified conditions and for the intended purposes.
If within the warranty period any such product shall be proved
defective, such product will be repaired or replaced at Circle Spe-
cialty’s option.
If you have a question about your Circle Specialty walker or this
warranty, please contact an authorized dealer.
WARRANTY
Circle Specialty, Inc.
Brooklyn, NY 11232, USA
718.943.6452
2020/Rev 3-20
Seat Height
– Place seat on its back, remove securing screw (A)
from each inner leg and detach all 4 outer legs. Position each
outer leg at its desired height, insert screw (A) and tighten.
Additional height can be achieved by changing the placement of
the inner pin (B).
NOTE:
Anterior or posterior seat tilt can be achieved by posi-
tioning front and back legs at different heights.
Seat Depth
- Loosen knobs (C) under the seat and adjust to
desired position by sliding the seat forward or backwards.
Seat Width
– Hip Guide accessories are available to reduce seat
width and to provide additional support to child’s hips. They are
secured to the inside of the armrest using the hook and loop
fastener provided.
Seat to Floor Angle
– The Pango can be adjusted in increments
of 5º from 85
0
- 90
0
- 95
0
. Factory setting is at 90
0
. To change the
angle, remove screws (D), position seat at the desired angle and
tighten the screw (D).
Back Angle
– The Pango can be adjusted in increments of 5º
from 95
0
- 100
0
- 105
0
. Factory setting is at 95
0
. To change the
angle, remove knobs (E), position back at the desired angle and
tighten the knobs (E).
Armrest
- Loosen knob (F), slide armrest up or down to desired
position and tighten knob (F).
NOTE:
Armrests must be at same height when using the tray
accessory.
Pelvic Belt
- The pelvic belt is secured to the seat by two cam
locks under the seat. To adjust the belt, lift each cam lock (G),
adjust the straps to desired length and close each cam lock. The
padded side-release buckle (H) should be placed with the buckle
facing away from the child and the pad placed behind the buckle
for comfort and protection.
8
