Operations
MediaVault 4105 User Manual
5-6
MV 4105_Ciprico Inc.
TABLE 5-3.
Rear Panel Components.
Component
Description
FC Port 1,
FC Port 2
FC Port 1 and FC Port 2 (on Side A or Side B) can accept a Fibre Channel SFP with
an LC Duplex optical cable.
See
“Fibre Channel Connections”
in Chapter 4,
Installation
.
MODE SELECT
Used to change the mode (RAID type) number. See
“Mode (RAID Type) Change
Procedure”
on page 5-12.
Unit Fan
Vents heat from the interior of the MV 4105.
DIAG
The Diagnostic port is used to enable firmware downloads or perform special
diagnostics. See
“DIAG - Diagnostic Port”
in Chapter 4,
Installation
.
Power On/Off
In the “On” (1) position, the power switch provides power to the MV 4105.
In the “Off” (0) position, the MV 4105 is powered-off.
To completely remove power from the MV 4105, disconnect the power cable from the
power cable receptacle.
MODE SET
A multi-function button. See the description in the
“Mode Set Button”
section on
page 5-13.
Receptacle,
Power Cable
Power receptacle for 100-240 Vac power cable to the auto-ranging power module
(power supply).
Fan, Power Supply
Vents heat from the power supply.
Hub LEDs
LINK LED: Indicates that communications are established between the Fibre
Channel microprocessor inside the MV 4105 and the built-in hub of the MV 4105.
SYNC LED: Indicates that the FC speed is established between the built-in hub
portion of the MV 4105 and the device to which this port is connected.
ACTIVE LED: Indicates that data is being transmitted.
