Cipia Vision Ltd.
–
Proprietary & Confidential
Page 25 of 38
#
Function
Description
defined in a command, if the time frame is still available in
the device’s memory and if the requested time frame is no
longer than 10 minutes.
The OTA bi-directional protocol supports the described
video capturing commands:
•
‘Start recording now’ command.
•
‘Retrieve footage from Memory’ command.
8
Power Management
The Cipia-FS10 app distinguishes between 3 power modes:
(1) ON, (2) OFF, (3) Standby/sleep
Ignition line is the usual trigger for transitions between ON
and SLEEP modes.
OFF mode is the power state of the device during shipment
or after loss of external power and depletion of internal
backup battery.
In normal operation, after the device is connected to an
8-32V power source, it would never go OFF, unless main
power source is disconnected.
If Main Button settings_Param1 is set to
‘enabled’,
pressing on the main button for between 5 and 10
seconds, while the Cipia-FS10 device is ON, triggers the
device to enter sleep mode.
If Main Button settings_Param1 is set to
‘disabled’
, the
user is never able to put the device into SLEEP mode.
Regardless of the setting of the Main Button
settings_Param1, if the device is powered, it monitors the
Ignition line and moves between SLEEP and ON modes
accordingly.
Transitions between power modes is reported to the server
if the corresponding events are enabled.
Upon detection of power drop below 7V, on the power
input line, for longer than the time set in config file
parameter, the Cipia-FS10 device generates an error event
with the appropriate reason (and the cyclic video buffer)
and commences a shutdown procedure that is completed
in less than 20 seconds. The Cipia-FS10 device wakes up
again once reconnected to a stable 7-32V power source.
If there is no connection to the server at the time of the
power loss, the event is stored in NVM and uploaded upon
the next successful power-up.
9
Tampering detection
The Cipia-FS10 application continuously monitors the
installation angles of the device using it embedded 3D
Accelerometer, and if a deviation from the original
installation is identified (as was acquired during
calibration), an error event with the appropriate reason
(device shifted) is generated.
In addition, if the image is lost (camera is blocked), or no
activity is detected, during DRIVE state for more than 30
