CipherLab 2564MR, User Manual

Page: 185 / 283

2564MR Barcode Scanner User Guide
5.2 CHARACTER SUBSTITUTION
Character substitution is performed on every occurrence of the first character specified. If
only one character is specified, every occurrence of that character in the barcode will be
taken away.

The first character will be replaced by the second character(s).

Up to three sets of character substitution can be configured.

If “BT HID”, “USB HID” or “Keyboard Wedge” is configured for interface, Key Type
and Key Status will then become applicable. You may decide whether or not to apply Key
Status when “Normal Key” is selected for Key Type.
Key Type Key Status
Scan Code Only 1 scan code value is allowed. Refer
to 5.2.1 Select a Set for Character
Substitution.
N/A
Normal Key Up to 3 character strings are allowed.
 Add Shift

Add Left Ctrl
 Add Left Alt
 Add Right Ctrl
 Add Right Alt
Refer to Keyboard Wedge Table.
Note: The character substitution is performed only on the barcode itself and before the
processing of editing formats. It is not applicable to the Prefix/Suffix Code, Code ID,
Length Code, or any Additional Field.
5.2.1 SELECT A SET FOR CHARACTER SUBSTITUTION
Configure Set 1
176
Enter Setup