CipherLab 1564, User Manual

Page: 50 / 141

40
Enter Setup
1564 Barcode Scanner User Guide
1.6.6 ALTERNATE MODE
The scanner will start scanning once the trigger is pressed
 The scanning won't stop until you press the trigger again.
Alternate Mode
1.6.7 AIMING MODE
The scanner will aim at a barcode once the trigger is pressed, and start scanning when
the trigger is pressed again within one second.

The scanning won't stop until (1) a barcode is decoded, and (2) the pre-set timeout
expires.
Aiming Mode
Aiming Timeout
You can limit the aiming time interval (1~15). By default, the scanner time-out is set to 1 second.
Aiming Time-out
after 1~15 sec.
(*1)
1. Read the barcode above to specify the time interval before aiming ends. (It is set to 1 by
default.)
2. Read the “ Decimal Value ” barcode on page
錯誤
!
尚未定義書籤。
. For example, read “1” and “0”
for the scanner to automatically shut down after being idle for 10 seconds.
3. Read the “Validate” barcode on the same page to complete this setting.