CO
-
100/P2102
Series | User Manual
9
Safety Precautions
Before installing and using this device, please note the following precautions.
1.
Read these safety instructions carefully.
2.
Keep this User’s Manual for future reference.
3.
Disconnected this equipment from any AC outlet before cleaning.
4.
For plug-in equipment, the power outlet socket must be located near the equipment and
must be easily accessible.
5.
Keep this equipment away from humidity.
6.
Put this equipment on a reliable surface during installation. Dropping it or letting it fall
may cause damage.
7.
Make sure the voltage of the power source is correct before connecting the equipment
to the power outlet.
8.
Use a power cord that has been approved for using with the product and that it matches
the voltage and current marked on the product’s electrical range label. The voltage and
current rating of the cord must be greater than the voltage and current rating marked on
the product.
9.
Position the power cord so that people cannot step on it. Do not place anything over the
power cord.
10.
All cautions and warnings on the equipment should be noted.
11.
If the equipment is not used for a long time, disconnect it from the power source to avoid
damage by transient overvoltage.
12.
Never pour any liquid into an opening. This may cause fire or electrical shock.
13.
Never open the equipment. For safety reasons, the equipment should be opened only
by qualified service personnel.
If one of the following situations arises, get the equipment checked by service
personnel:
⚫
The power cord or plug is damaged.
⚫
Liquid has penetrated into the equipment.
⚫
The equipment has been exposed to moisture.
⚫
The equipment does not work well, or you cannot get it work according to the user's
manual.
⚫
The equipment has been dropped and damaged.
⚫
The equipment has obvious signs of breakage.
14.
CAUTION: Danger of explosion if battery is incorrectly replaced. Replace only with the
same or equivalent type recommended by the manufacturer.
15.
Equipment intended only for use in a RESTRICTED ACCESS AREA.
Summary of Contents for CO-100/P2102 Series
