OMM-05-0509-page 1
BLOWER SERIAL NUMBER: ________________________
MFG. DATE: ____________________
NOTE:
The serial number above is a required reference for any assistance. It is stamped on the blower nameplate.
BLOWER SPECIFICATIONS:
Model: ________
Arrangement: ________
Rotation: ________
Discharge: ________
Nominal Inlet Size: ________
(in Inches)
Wheel Size and Type: ___________________
BLOWER PERFORMANCE DATA:
(If entered on order)
CFM:
________
SP:
________ (Inches of Water Gauge)
Motor BHP:
________
Density:
________
Altitude:
________ (Ft. above S.L.)
Airstream Temperature:
________°
F.
Fan RPM:
________
Maximum Safe Fan RPM:
____________
DO NOT EXCEED THIS RPM
Installation, Safety, Operation & Maintenance Instructions And Parts List
For Models PB, PBS, SPB, LM, HP-Series I & II, RBE, HDBI and HDAF.
Arrangement 1 Blowers
All Cincinnati Fan products are packaged to minimize any damage during shipment. The freight carrier is responsible
for delivering all items in their original condition as received from Cincinnati Fan. The individual receiving this equipment
is responsible for inspecting this unit for any obvious or concealed damage. If any damage is found, it should be noted
on the bill of lading before the freight is accepted and the receiver must file a claim with the freight carrier.
ATTENTION: RECEIVING DEPARTMENT
Since Cincinnati Fan does not supply any electrical components used with Arrangement 1 blowers, it is the purchasers
and/or users responsibility to make sure all electrical components used with this blower are in compliance with all compa-
ny, local, state and federal regulations governing the use of this blower for the specific application it was originally pur-
chased for. This includes all component selection, proper installation and maintenance of any component or parts that will
be used in conjunction with this blower. The purchaser and/or user also assumes responsibility for warranty of the blower
wheel, shaft and bearings should a failure occur due to improper alignment of the blower and motor shafts or sheaves
and belts, operating the blower above the vibration limits or operating the blower above its maximum speed limit.
NOTICE
LONG TERM STORAGE NOTICE
If this blower will NOT be installed and put into operation within 30 days, refer to the “Long Term Storage
Instructions” on page 13. Failure to follow all applicable long term storage instructions, will void your warranty.
This blower should be stored indoors in a clean, dry location.
BLOWER SPECIFICATIONS
Form: OMM-05-0509
Effective: 5/4/09
Supersedes: OMM-05-0207
Part No.: 01223
READ ENTIRE MANUAL INCLUDING “SECTION IV. INITIAL UNIT STARTUP” BEFORE
ATTEMPTING TO INSTALL AND OPERATE THIS EQUIPMENT.
NOTE
