STACK-O!
Testing System
CEP STACK-O! Manual Rev. 2.1
User’s Manual
July 15, 2016
Page 9
4.4 Troubleshooting
PROBLEM
POSSIBLE CORRECTIVE ACTION
STACK-O! does not power up.
Confirm that the STACK-O! power source
is present and within specification.
Check the fuse and replace if necessary.
STACK-O! powers up but main screen
with CIMTEC logo and height data
does not appear on screen after the
power-up screen disappears.
Go to System Setup Screen by pressing
the System button and confirm that the
PLC Status is
“Run”. If not, maneuver to
the Status line, press the Enter
button
and use the arrow keys to change the
Status to
“Run” and press the Enter
button. Confirm that the Status is
“Run”
and press the
“Esc” button twice. The
main screen should appear.
If the PLC Status is
“Run” and the main
screen does not appear, please contact
CIMTEC for further assistance.
STACK-O! powers up but one or both
of the short range distance sensors
’
lasers do not appear to be on.
Power down the STACK-O! and confirm
that the sensor’s lens is clean and
unobstructed.
Incorrect measurements.
Remove all product from the STACK-O!
and recalibrate the STACK-O! (section
3.2), then re-check the measurements.
