7
MIXER USE: PRELIMINARY OPERATIONS
-
SWITCH ON THE MACHINE WITH THE MAIN REAR GENERAL SWITCH.
-
LIFT UP THE TOP MOTOR
( M )
WITH KNOB
( A )
AND TURN IT TO THE RIGHT SIDE OF THE UNIT.
-
REMOVE THE CAP
( REF 7 )
FROM THE BLADE COVER
( B )
-
REMOVE THE TOP MIXING COVER WITH ITS BLADE
( B )
FROM THE MIXING CHAMBER
( C )
-
LIFT UP THE COMPLETE MIXING CHAMBER
( C )
AND PLACE IT READY FOR THE INVESTMENT
POWDER LOADING. ( MIXING CONTAINER ALWAYS DRY PLEASE )
-
PLACE THE FLASKS TO BE PROCESSED ON THE ROUND FLASK PLATE
( D ):
YOU COULD TAKE
OUT THE FLASK PLATE FROM ITS LOCATION FOR EASY PREPARATION OF FLASKS DISPOSITION.
BE SURE TO MATCH THE EXAGONAL PIN WHEN REPLACING THE FLASK PLATE ON ITS ORIGINAL
POSITION.
INVESTMENT POWDER LOADING AND MIXER PREPARATION:
BE SURE THAT BOTTOM POURING VALVE TAP ( REF 8 ) IS CLOSED.
WE SUGGEST TO PLACE THE MIXING CONTAINER ON A DIGITAL SCALE AND MAKE THE TARE
BEFORE LOADING THE INVESTMENT POWDER IN THE QUANTITY NEEDED.
OTHERWISE MAKE THE EXACT WEIGHT OF THE POWDER AND POUR IT INTO THE CHAMBER
AVOIDING BREATHING THE INVESTMENT DUST. USE ALWAYS MASK AND GLOVES PROTECTION !
ONCE LOADED, PLACE THE MIXING CONTAINER ON ITS LOCATION CARING:
-
A) CORRECT MATCHING FOR THE MIXING CONTAINER ON THE FLASK CHAMBER
(REF. F )
-
B) CORRECT MATCHING OF THE STICKER LINE REFERENCE BETWEEN THE LOWER MIXING
CONTAINER BASE AND THE FLASK PLEXIGLASS CHAMBER.
(REF. E) –
TWO VERTICAL
REFERENCES LINES
-
INSERT THE MIXING BLADE
(REF. G)
INTO THE MIXING CHAMBER CARING THAT COVER WILL
SEAL PERFECTLY THE CHAMBER TOP.
-
LOCATE THE TOP MOTOR IN THE ORIGINAL POSITION CARING TO INSERT THE TRANSMISSION
SHAFT CORRECTLY. ( if the operation get DIFFICULT and not matching: SIMPLY START AND STOP
THE MIX BUTTON ON THE CONTROL PANEL.
-
PLACE AGAIN THE CAP
(REF. 7 )
IN THE ORIGINAL POSITION
-
VERIFY THAT ITS TAP
(REF. 6 )
IS CLOSED ( CROSSING PERPENDICULARLY THE PIPE DIRECTION )
Example: as described above
(KG. 1,7 POWDER )
TOP LEVEL LINE
----- OF WATER
1
MEANS THAT WE HAVE LOADED
KG. 1 OF DRY POWDER
The quantity of water from top line until
line indicating 1 is the 40% ratio (400 cc. )
