TRANSTIG 220AC/DC AND 300AC/DC POWER SOURCE
INSTALLATION, OPERATION AND SETUP
3-4
Manual 0-5293
3.08 TRANSTIG 220AC/DC and 300AC/DC Power Source Controls, Indicators and
Features
A-12033
Figure 3-1: Controls on Front and Rear Panel
1. Electrode Welding Terminal
Electrode Welding Terminal. Welding current flows from the Power Source via heavy duty bayonet type
terminals. It is essential, however, that the male plug is inserted and turned securely to achieve a sound
electrical connection.
2. 8 Pin Control Socket
The 8 pin receptacle is used to connect a trigger switch or remote control to the welding Power Source
circuitry:
To make connections, align keyway, insert plug, and rotate threaded collar fully clockwise. The socket
information is included in the event the supplied cable is not suitable and it is necessary to wire a plug or
cable to interface with the 8 pin receptacle.
Socket Pin
Part Number / Description
1
Not used
2
Trigger Switch Input
3
Trigger Switch Input
4
Not used
5
Remote Control 5k ohm Potentiometers Maximum
6
Remote Control 5k ohm Potentiometers Minimum
7
Remote Control 5k ohm Potentiometer Wiper
8
Not used
Table 3-1: 8 Pin Interconnection Control Plug Configuration Figure 3-2: 8 Pin Control Socket
A-12055
Summary of Contents for A-12030
Page 6: ......
