Cidco D933, User Manual

Page: 24 / 31

D933 - 900MHz Cordless
15 USING THE D933
A
DJUSTING THE
V
OLUME
A
DJUSTING THE
H
ANDSET
V
OLUME
a. Press the TALK key.
b. Press the or VOLUME key on the side of
the handset while the phone is in use to
increase or decrease the volume. There are
four volume levels.
A
DJUSTING THE
H
ANDSET
R
INGER
V
OLUME
a. Press the or VOLUME key on the side of
the handset while the phone is not in use.
b. You hear the sound of the ringer as you
adjust the volume. The ringer volume can be
set at different levels of rings.
U
SING
H
OLD
You can place a call on hold by pressing the
HOLD
key. The
Talk light flashes slowly while calls are on hold.
There are three ways to take a call off hold:
a. Press TALK or
HOLD
to resume the call.
b. Pick up the call on another extension.
c. The caller hangs up.
T
IMING
C
ALLS
When you are on a call, a call timer is displayed. The timer
counts the entire length of the time you are on the phone.
When the timer goes past 99 minutes and 59 seconds, it
starts over at 0:00.
T
EMPORARY
T
ONE
S
ERVICE
If your phone is set to Pulse and you need Tone service for
interacting with bank and other automated services, you can
temporarily change your dial setting to Tone. Press
*
during
the call and the phone switches to temporary Tone service
for the duration of the call. The phone returns to Pulse
service when you hang up. See “Selecting a Dialing Method”
on page 11.
L
OCATING A
L
OST
H
ANDSET
Should you misplace your handset, you can locate it quickly
and easily by pressing the
PAGE / FIND
key on the base. The
handset beeps for 20 seconds, or until you either
■
Press the PAGE / FIND key again
or
■
Press any key on the handset.
If the handset does not beep, it is either out of range, or the
battery needs recharging.
L
OW
B
ATTERY
When the handset battery charge becomes low you will hear
an audible tone and will see the display message
RECHARGE
BATTERY . You have approximately 5 minutes to conclude
your call or switch phones before your call is dropped.
NEED TO KNOW
Prior to first use, place the handset in the cradle
and charge the battery for at least 12 hours.
The charge light on the base comes on to tell
you that the handset is charging.