CIARA Astro PB60S
- 23 -
1.5.7 Solving memory problems
Solving memory problems
Problem
Cause
Solution
System will not boot or does not
function properly after installing
additional memory modules.
Memory module is not the
correct type or speed grade
for the system or the new
memory module is not seated
properly.
Replace memory module with a module approved
for your system. See Sections 1.6.4 of the present
Guide to verify if you have installed memory
modules compatible to your system and if they were
installed correctly.
Out of memory error.
You have run out of memory
to run the application.
Check the application documentation to determine
the memory requirements.
Insufficient memory error
during operation.
Too many programs are being
used.
Close any programs that you do not need.
You have run out of memory
for the application.
Check the memory requirements for the application
or add more memory to the computer.
Power LED flashes five times,
once every second, followed by
a two second pause, and the
micro PC beeps three times.
Memory is installed
incorrectly or is bad.
1.
Reseat DIMMs. Power on the system.
2.
Replace DIMMs one at a time to isolate the
faulty module.
3.
If a faulty module is found, Contact CIARA for
the replacement of the module.
4.
4. If the problem persists, Contact CIARA for this
may necessitate the replacement of the
motherboard.
1.5.8 Solving processor problems
Solving processor problems
Problem
Cause
Solution
Poor performance is experienced. Processor is hot.
1.
Make sure the airflow to the computer is not
blocked.
2.
Make sure the fans are connected and working
properly (some fans only operate when needed)
3.
Make sure the processor heatsink is installed
properly.
4.
Make sure the processor fan connector is
properly connected to the CPU_FAN header on
the motherboard.
5.
Make sure sufficient thermal compound has
been applied on the processor before the heat
sink is put in place. This ensures that heat is
drawn away from the processor to the heat sink.
Power LED is always on
OR
Power LED flashes three times,
once every second, followed by a
two second pause.
Processor is not seated
properly or not installed.
1.
Check to see that the processor is present.
2.
Reseat the processor. See section 1.6.3 of the
present Guide for more information.
Summary of Contents for Astro PB60S
Page 1: ...Astro PB60S User Guide...
Page 67: ...CIARA Astro PB60S 67 NOTES...
Page 68: ...CIARA Astro PB60S 68...
