Chrysler 2006 300C SRT8, Owner'S Manual

Page: 118 / 320

NOTE: To program the remaining two HomeLink but-
tons, begin with
⬙
Programming
⬙
step two. Do not repeat
step one . For questions or comments, please contact
HomeLink at
www.homelink.com or 1-800-355-3515
.
Canadian Programming/Gate Programming
Canadian radio-frequency laws require transmitter sig-
nals to
⬙
time-out
⬙
(or quit) after several seconds of
transmission which may not be long enough for
HomeLink to pick up the signal during programming.
Similar to this Canadian law, some U.S. gate operators are
designed to
⬙
time-out
⬙
in the same manner.
If you live in Canada or you are having difficulties
programming a gate operator by using the
⬙
Program-
ming
⬙
procedures (regardless of where you live), replace
ⴖ
Programming HomeLink
ⴖ
step 3 with the following:
NOTE: If programming a garage door opener or gate
operator, it is advised to unplug the device during the
⬙
cycling
⬙
process to prevent possible overheating.
3. Continue to press and hold the HomeLink button
while you
press and release every two seconds (
⬙
cycle
⬙
)
your hand-held transmitter until the frequency signal has
successfully been accepted by HomeLink. The EVIC
display will show “Channel X Trained” (where X is
Channel 1, 2, or 3). Proceed with
⬙
Programming
⬙
step
four to complete.
Using HomeLink
To operate, simply press and release the programmed
HomeLink button. Activation will now occur for the
trained device (i.e. garage door opener, gate operator,
security system, entry door lock, home/office lighting,
etc.). For convenience, the hand-held transmitter of the
device may also be used at any time. In the event that
there are still programming difficulties or questions,
contact HomeLink at:
www.homelink.com or 1-800-355-
3515 .
Erasing HomeLink Buttons
To erase programming from the three buttons (individual
buttons cannot be erased but can be
⬙
reprogrammed
⬙
-
note below), follow the step noted:
•
Press and hold the two outer HomeLink buttons and
release only when the EVIC display shows “Channels
Cleared” (after 20 seconds). Release both buttons. Do
not hold for longer that 30 seconds. HomeLink is now
118 UNDERSTANDING THE FEATURES OF YOUR VEHICLE