Studio One 100 T User Manual
13
V1.0 September 2015
www.chroma-q.com
5-Reset
To reset the fixture to the factory default settings,
1.
From the Main Menu, press Up
Up
Up
Up or Down
Down
Down
Down to access 5-Reset.
2.
Press Enter
Enter
Enter
Enter, display shows reset?
3.
Press and hold Enter
Enter
Enter
Enter for 2 seconds, display shows Hold for 2 sec. and Done, then back to the Main
Menu.
All control menu commands are reset to factory defaults:
DMX address
1
Personality
Dimmer
No DMX Present Hold Last
Look Store
1
PWM Frequency 750Hz
2.6
DMX Protocol
DMX Personality:
Studio
Studio
Studio
Studio One
One
One
One 100
100
100
100 T
TT
T
V1.
V1.
V1.
V1.6
6
6
6
1-Dimmer
[1 ch]
Channel 1
All LED
Total
1 DMX channel
2.7
Thermal Performance
The internal cooling system of the Studio One fixture is by convection and built with automatic protection. The fixture’s
automatic protection reduces the output when the internal temperature reaches the maximum limit due to extreme ambient
conditions.
3.
Troubleshooting
Troubleshooting is a process of elimination. First, rule out the other field factors (i.e. bad connections, faulty cables and
power supplies). For technical support and/or parts, please contact your selling dealer or the offices listed in this manual.
Symptom
Possible Cause
Solution
Fixture does not respond to DMX
control.
Set to wrong or different DMX address.
Bad cable connecting DMX control and
fixture.
Bad in/through connection between
adjacent fixtures.
Check DMX address and Mode
settings.
Check/replace DMX run from the
console.
Low LED output.
Internal temperature is over the limit.
Check area ventilation.
