Space Force Manual Yoke Installation Quick Start Guide V1.1
Part No. CHSPFSY
Model: 650-0903
3.
Installation Guide
Procedure:
1.
Install the Brackets on both sides of space force unit using
PZ1 x 80mm screw driver.
2.
Tighten the screws to make a solid connection.
3.
On the yoke arm with the 12mm hole, place the Rubber gasket in between the Yoke and the Side bracket. Place
the Rubber gasket in parallel to the Side bracket and then place the Yoke opposite and in line with it.
4.
Place the Bearing set on outer side of the yoke, and then install the offset handle.
5.
Press and spin clockwise the offset handle to allow the threaded screw to go into the threaded hole of the
Side Bracket. Rotate until the joint is tightened.
