Manual Operation
3-17
3.3.2.5
Setting DC_ON
DC_ON has two settings for selection. One is when the output of DC power supply is ON
and the voltage is over VDC_R, the pin10 DCOUT_ON of ANALOG INTERFACE on the rear
panel will turn to HIGH. When the output of DC power supply is OFF and the voltage is
lower than VDC_F, the pin10 DCOUT_ON of ANALOG INTERFACE on the rear panel will
turn to LOW for other usages as Figure 3-24 shows. Another is when DC power supply
output is ON, the pin10 DCOUT_ON of ANALOG INTERFACE on the rear panel will turn to
HIGH and when the DC power supply output is OFF, the pin10 DCOUT_ON of ANALOG
INTERFACE on the rear panel will turn to LOW for other purpose use.
VDC_R
VDC_F
t
VO
DC_ON
Figure 3-24
Set DC_ON as described below:
1.
For the first setting, u
se “
”, “
keys to move the cursor to the column to
be set as Figure 3-25 shows.
Figure 3-25
2.
Use the numeric (
0
~
9
) keys or “Rotary” (
) knob to set the value. The low
limit is 1%Vmax and the upper limit is 99%Vmax. For instance, the lower limit of
DC_ON is 6V and the upper limit is 594V for 62150H-600S.
3.
For the second setting,
use “
”, “
” keys to move the cursor to the column
to be set as Figure 3-26 shows.
