Program Sequence
4-3
4.1.1.1
Setting EXT._TRIG PULL
1.
Use “
”, “
” keys to move to the cursor to the column to be set as Figure
4-3 (1) shows.
2.
Use numeric keys
0
~
1
or “Rotary” (
) to set HIGH or LOW.
3.
Press “
ENTER
” to confirm.
4.
Press “
EXIT
” to return to Figure 4-1.
1.
When the EXT._TRIG PULL is set to HIGH, the user has to input a
negative edge trigger signal (TTL level) from the Analog Interface
PIN 8 on the rear panel to jump to the next sequence.
2.
When the EXT._TRIG PULL is set to LOW, the user has to input a
high level signal from the Analog Interface PIN 8 on the rear panel
and change it to low level signal (negative edge trigger) to jump to
the next sequence.
4.1.1.2
Setting PROG NO.
1.
Use “
”, “
” keys to move the cursor to the column to be set as Figure 4-3
(2) shows.
2.
Use the numeric (
0
~
9
) keys or “Rotary” (
) knob to set the value.
3.
Press “
ENTER
” to confirm.
4.
Press “
EXIT
” to return to Figure 4-1.
[ P R O G R A M ]
E X T . _ T R I G P U L L = H I G H _
P R O G N O .
=
1
R U N C O U N T
= 1
P R O G C H A I N =
N O
C L E A R P R O G
= N O
▼
( 1 )
( 2 )
( 3 )
( 4 )
( 5 )
Figure 4-3
Since there are 10 programs for setting, the valid range of PROG NO. is 1 ~ 10.
4.1.1.3
Setting RUN COUNT
1.
Use “
”, “
” keys to move the cursor to the column to be set as Figure 4-3
(3) shows.
2.
Use numeric keys
0
~
9
or “Rotary” (
) knob to set the value.