Christie Solaria One, Service Manual

Page: 37 / 88

Section 3: Parts and Module Replacement
Solaria One/Solaria One
+
Service Manual 3-9
020-101039-02 Rev. 1 (06-2013)
5. Open the integrator rod access door and loosen the second service panel screw.
6. Push the clips on the top of the service panel down and out to remove the service panel.
3.12 Remove the Exhaust Panel Skin
The exhaust panel is located on the left when facing the rear of the projector. The exhaust panel skin includes
the service panel that you can remove separately to access to optical components. The exhaust panel skin
rarely needs to be replaced because you can remove the side skin service door to access internal components.
1. Turn the lamp off and cool the projector for at least 15 minutes.
2. Turn the projector off and then disconnect it from AC power.
3. Remove the top lid. See
Remove the Top Lid on page 3-4 .
4. Remove the service door. See Remove the Service Door on page 3-8 .
5. Loosen the 3 screws from the bottom of the exhaust panel skin.
6. Remove the top 4 hex screws.
7. Pull the skin forward and out.
3.13 Remove the Safety Shield
EXPLOSION HAZARD! Wear Christie approved protective clothing (598900-
95) whenever the safety shield is open and when handling the lamp.
The safety shield is positioned above the lamp reflector and is used to block UV light.
1. Turn the lamp off and cool the projector for at least 15 minutes.
2. Turn the projector off and then disconnect it from AC power.
3. Remove the top lid. See
Remove the Top Lid on page 3-4 .
4. Loosen the 2 captive screws.