Connecting the product power cables to the
Remote Power Supply Rack Shelf
Connect the cables between the product and the Remote Power Supply Rack Shelf.
1. Connect the main power cable to the Remote Power Supply Rack Shelf.
2. Connect the main power cable to the product.
If the power cord supplied with your product is not long enough to connect the first display
panel in an array to the Remote Power Supply Rack Shelf module, you must purchase a power
cord of an adequate length. Christie recommends one of the pre-terminated power cables
offered as Christie accessories, or that you create a custom cable using the Christie Main
Power Cable Spool (P/N 154-122106-XX), Connector Kit (P/N 154-125109-XX), and Molex
Crimping Tool (P/N 154-124108-XX). For more information on the Molex Crimping Tool, see the
Molex documentation.
3. Plug the Remote Power Supply Rack Shelf into the building outlets in the wall or the floor.
Logging in to the Remote Power Supply Rack
Shelf web interface
To make changes to the Remote Power Supply Rack Shelf, use Internet Explorer.
1. Connect a computer to the Remote Power Supply Rack Shelf with a network crossover cable.
2. To access the web interface, in the Control Panel, change the IP address and subnet mask of
the computer to be on the same subnet as the Remote Power Supply Rack Shelf.
If the IP address and subnet mask on the Remote Power Supply Rack Shelf have not been
changed from the default, use the following values on the computer:
•
IP address: 10.10.10.202
•
Subnet mask: 255.255.255.0
3. Turn off any browser pop-up blockers.
4. In the browser address bar, type the IP address of the Remote Power Supply Rack Shelf
device.
The default IP address is 10.10.10.201.
If you have changed the IP address of the Remote Power Supply Rack Shelf, the IP address
and subnet mask of the computer must also be changed.
The IP address for the web interface is one digit higher than the IP address of the device. For
example, when the IP address of the device is 10.10.10.201, the address of the web interface
is 10.10.10.202.
5. If prompted, run the MSXML add-on.
6. Log in to the Remote Power Supply Rack Shelf with your username and password.
The default username is Admin, and the default password is 1234.
Installing and configuring the Remote Power Supply Rack Shelf
Remote Power Supply Rack Shelf Installation and Setup Guide
9
020-102093-03 Rev. 1 (04-2018)
Copyright
©
2018 Christie Digital Systems USA, Inc. All rights reserved.
