Installing the long pieces of the trim kit on an
array
Learn how to install the long pieces of the trim kit on an array.
If the array is in landscape orientation, for improved ventilation behind the display panels Christie
recommends only installing the long pieces of the trim kit along the bottom of the array.
1. Mount the display panels on to a fully assembled wall mount that is secured to a mounting
surface.
2. Verify that all display panels in the array are correctly aligned.
3. Pull the display panel away from the wall mount.
4. If needed, remove the cable pass-through cover.
Caution! If not avoided, the following could result in minor or moderate injury.
•
Metal parts may have exposed sharp edges.
Removing the pass-through cover may leave sharp edges on the trim. Use a metal file to
remove the sharp edges.
5. Using the M4 round-head screws, attach four trim kit brackets to the rear of the panel.
6. Using four M3 round-head screws and four M5 round head screws, loosely secure one of the
long pieces of the trim kit on to a long side of the array.
7. Pushing evenly on each side of the display panel, guide the display panel back into place until
the locking tabs engage.
8. Adjust the trim kit to cover the gap between the panel and the wall.
9. Tighten the trim kit screws.
10. Repeat steps 5 to 9 for the long side of all panels at the edge of the array.
Installing the MPL15 wall mount trim kit on 49" LCD display panels
Installing the MPL15 Wall Mount Trim Kit on 49" LCD Display Panels Instruction Sheet
2
020-103048-01 Rev. 1 (02-2019)
Copyright
©
2019 Christie Digital Systems USA, Inc. All rights reserved.
