Attaching the adapter brackets to the display
The panel must have the adapter brackets installed before it can be attached to the wall bracket.
Attach the adapter brackets to the back of the panel using eight M8 x 15 mm socket pin
screws.
For 55" panels, insert the spacer between the adapter brackets and the panel before attaching
the brackets with the M8 socket pin screws.
For 49" panels, the spacers can be used but the installed panel will be more than 4" from the
wall.
Attaching the panel to the wall mount
Install the panel with the brackets onto the wall mount.
1. Hang the adapter brackets onto the wall mount and slide into position.
2. Loosely fasten the panel in place using the security screw.
3. To lock the panel in place, use a Phillips screwdriver to tighten the security screws.
Adjusting the panel up and down
Use the height adjustment screw to move the panel up and down.
1. Loosen the security screws.
2. Turn the height adjustment screw clockwise to raise a side.
3. Turn the height adjustment screw counter-clockwise to lower a side.
Installing flat panels on the ML20 wall mount
Installing Flat Panels on the ML20 Wall Mount Instruction Sheet
7
020-102525-01 Rev. 1 (02-2017)
Copyright
©
2017 Christie Digital Systems USA Inc. All rights reserved.
