Installation safety and warning guidelines
Read all safety and warning guidelines before installing the projector.
Warning! If not avoided, the following could result in death or serious injury.
•
Possible hazardous optical radiation emitted from this product. (Risk group 3)
•
High leakage current present when connected to IT power systems.
•
Christie products must be installed and serviced by Christie qualified technicians.
•
Do not operate the product without all of its covers in place.
•
A minimum of four people or appropriately rated lift equipment is required to safely lift, install,
or move the product.
•
Always install safety straps when the frame and projector are installed overhead.
•
Observe load ratings and applicable local safety codes.
•
When installing the projector in portrait mode, the rigging device must have a sufficient load
rating, as identified in this manual.
•
•
This product must be installed within a restricted access location not accessible by the general
public.
•
Install the product so users and the audience cannot enter the restricted area at eye level.
•
Only personnel who are trained on the precautions for the restricted access location can be
granted entry to the area.
•
Only Christie qualified technicians are permitted to open product enclosures.
Caution! If not avoided, the following could result in minor or moderate injury.
•
ELECTRICAL and BURN HAZARD! Use caution when accessing internal components.
•
Only Christie qualified technicians are authorized to use the tools provided in the toolbox.
Light intensity hazard distance
This projector has been classified as Risk Group 3 as per the IEC62471 standard due to possible
hazardous optical and thermal radiation being emitted.
Warning! If not avoided, the following could result in serious injury.
•
PERMANENT/TEMPORARY BLINDNESS HAZARD! No direct exposure to the beam must be
permitted.
•
PERMANENT/TEMPORARY BLINDNESS HAZARD! Operators must control access to the beam
within the hazard distance or install the product at the height that prevents exposure of
spectators' eyes within the hazard distance. The hazard zone must be no lower than 3.0 meters
above the floor and the horizontal clearance to the hazard zone must be a minimum 2.5 meters.
•
EXTREME BRIGHTNESS! Do not place reflective objects in the product light path.
The following show the zones for ocular and skin hazard distances.
Introduction
Mirage 304K (Bm.1) Installation and Setup Guide
8
020-102013-12 Rev. 1 (09-2022)
Copyright
©
2022 Christie Digital Systems USA, Inc. All rights reserved.
If printed, please recycle this document after use.
Summary of Contents for Mirage 304K
Page 1: ...Installation and Setup Guide 020 102013 12 Mirage 304K Bm 1...
Page 68: ......
