ID
Component
Description
K
Adjustable feet
Raise or lower these feet when positioning the projector to make sure it
is level on all sides so the displayed image appears rectangular without
any keystone.
L
Service compartment
Access to fold mirror, optical zoom/focus, and DMD convergence
adjustments.
M
Tool box
Provides tools for Christie qualified technicians.
N
Rear IR
Receives transmissions from the IR remote.
O
LED status indicator
Indicates lamp and power status.
P
Shutter LED status indicator
Indicates shutter status.
Q
Lamp door
Access to lamp compartment.
R
AC lock
Locks Input 1 power cord.
S
AC Input 2: limited power
Use this IEC 320-C14 inlet to connect to an appropriately rated power
cord (component R) provided for your region. For use in limited power
mode.
T
AC Input 1: full power
Use this IEC 309 inlet to connect to an appropriately rated power cord
(component S) provided for your region. For use in full power mode.
U
Power cord: limited power
Connects the provided power cord appropriately rated for your region to
AC Input 2 for limited power mode.
V
Power cord: full power
Connects the provided power cord appropriately rated for your region to
AC Input 1 for full power mode.
IR/wired remote keypad
The IR/wired remote keypad controls the projector by way of either wireless communications from a
battery-powered infrared (IR) transmitter or a wired interface.
To use the IR remote, direct the keypad toward the projector’s front or rear IR sensor and press a
function key. One of the two IR sensors on the projector detect the signal and relay the commands for
internal processing. The remote also offers a connector for wired connections to the projector.
Installation and setup
Mirage 304K (Bm.1) Installation and Setup Guide
17
020-102013-12 Rev. 1 (09-2022)
Copyright
©
2022 Christie Digital Systems USA, Inc. All rights reserved.
If printed, please recycle this document after use.
Summary of Contents for Mirage 304K
Page 1: ...Installation and Setup Guide 020 102013 12 Mirage 304K Bm 1...
Page 68: ......